Stable diffusion WebUI Sampling method test (Failed, Incomplete)

(Test is 24.02.09)

Today, I'm gonna test for remove Sampling method that i don't use

Begining of the checkpoint model is Samaritan V3

As you can see, dpm 2a, dpm 2m sde heun  Sampling method show some sort of artifect errors

The Second checkpoint model is Astranime V5

lms, dpm++ 2m sde, DPM++ 3M SDE Sampling method show errors. 

Especially two at the end, looks After Detailer (AD) error

Next checkpoint model is HenMixReal V3

lms, dpm2 a, dpm++ 2m, DPM++ 2M SDE, DPM++ 3M SDE, unipc  show some errors.

Five at the end is same issuses. (AD error)

Now no sampler has a bad state(error) in common in all three situations

So I will run a new XYZ test that includes the three samplers that were excluded from the initial Samaritan test

Test start with fixed sampling method and comparison by checkpoints

The first Sampling method in LMS,

Check point that i use are two 3d checkpoint (3dAnimationDiffusion, samaritan3dCartoonV3), two 2.5d (astranime, PL), two realistic ( hen mix real V3, MHv2)

Every checkpoint show error,

How about  changing setting?

1. lower cfg(5).

the style of clothing is sometimes awkward, you can see that there is a common problem with AD in all checkpoints

2 higher steps(30). 

One model stood out significantly.

The result is similar as test1.

AD issue is certain. 

3 Both

(Excessive testing is pointless. After all, time consumption is also an important factor in choosing a sampler)

DPM++ 3M SDE

Cfg 5, 20 steps,

In AD error. Hm...

I'm gonna changing the AD settings, just in case

(because settings that i have used there is no issues before)

face denoising strength is 0.41, hand is 0.4. 

After AD setting changed (lower denoinsing), but still got ad issue. 

After update AD, Retry test. (Denoising face : 0.49, hand : 0.44)

The first test. Except 3d check point, every check point show errors.

The second test, Hen had errors in both face and hand. 

PL mix is just error in face.

The third test, every check point had errors

1.cfg 5

 Only the hen had errors.

 Only the hen had errors.

 

Only the hen had errors.

2.steps 30

 The first Just the hen checkpoint shows error in face again?

 The second. Wrong composition. Invalidation

The third.  astranime, pl ,hen check point face error.

 Just Hen...Why?

3.both

 Hen...

 Hen....?

 All OK

DPM++ 2M SDE

Why does it broke(errors) in AD?

Basic Sampling method that i use as usual is DPM++ 2M Karras

All ok

Temporary conclusion :  Either an issue with the ad itself or a Stable Diffusion WebUI bug. I'm unable to troubleshoot further, so the experiment ends here.